Verification results after converting a system to fixed point
DataTypeWorkflow.VerificationResult object contains the
results after converting a system to fixed point. The verification result object indicates
whether a conversion was successful based on the tolerances specified on the
DataTypeWorkflow.ProposalSettings object used during the
simulates the system specified by the
verificationResult = verify(
converter, and stores the run information in a new run,
RunName. It returns a
DataTypeWorkflow.VerificationResult object that compares the baseline
and verification runs.
DataTypeWorkflow.Converter object contains instrumentation data
from the run specified by
BaselineRunName, as well as the tolerances
specified on the associated
object. The software determines if the behavior of the verification run is acceptable
using the tolerances specified by the
RunName — Name of verification run to create
Name of the verification run to create during the embedded simulation, specified as a character vector.
BaselineRunName — Baseline run to compare against
Baseline run to compare against, specified as a character vector.
Status — Whether the verification run meets the specified tolerances
Whether the verification run meets the specified tolerances, returned as either
additional details, use
to display logged data in the Simulation Data Inspector.
|All signals with a specified tolerance on the associated
|One or more signals with a specified tolerance on the associated
|Explore comparison of baseline and fixed-point implementations|