Model a Counter for HDL and SystemC Code Generation
To write MATLAB® code that models hardware and is suitable for HDL and SystemC code generation, use this design pattern.
This design pattern demonstrates best practices for writing MATLAB code for HDL and SystemC code generation:
Initialize persistent variables to a specific value. In this example, an
ifstatement and the
isemptyfunction initialize the persistent variable. If you do not initialize the persistent variable, then you cannot generate HDL and SystemC code.
Inside a function, read persistent variables before they are modified so that the persistent variables are inferred as registers.
This Simulink® model illustrates the MATLAB counter modeled in this example.
To learn how to model the counter in Simulink, see Create HDL-Compatible Simulink Model.
MATLAB Code for the Counter
mlhdlc_counter is a behavioral model of a 4-bit synchronous
up counter. The input signal,
enable_ctr, triggers the value of
the count register,
count_val, to increase by one. The counter
continues to increase by one each time the input is nonzero, until the count reaches
a limit of 15. After the counter reaches this limit, the counter returns to zero. A
persistent variable, which is initialized to zero, represents the current value of
the count. Two
if statements determine the value of the count
based on the input.
To define the
mldhlc_counter function, use this code:
%#codegen function count = mlhdlc_counter(enable_ctr) %four bit synchronous up counter %persistent variable for the state persistent count_val; if isempty(count_val) count_val = 0; end %counting up if enable_ctr count_val=count_val+1; %limit to four bits if count_val>15 count_val=0; end end count=count_val; end