Linear resistor in electrical systems
Simscape / Foundation Library / Electrical / Electrical Elements
The Resistor block models a linear resistor, described with the following equation:
V is voltage.
I is current.
R is resistance.
Connections + and – are conserving electrical ports corresponding to the positive and negative terminals of the resistor, respectively. By convention, the voltage across the resistor is given by V(+) – V(–), and the sign of the current is positive when flowing through the device from the positive to the negative terminal. This convention ensures that the power absorbed by a resistor is always positive.
To set the priority and initial target values for the block variables prior to simulation, use the Variables tab in the block dialog box (or the Variables section in the block Property Inspector). For more information, see Set Priority and Initial Target for Block Variables.
+— Positive terminal
Electrical conserving port associated with the resistor positive terminal.
-— Negative terminal
Electrical conserving port associated with the resistor negative terminal.
Resistance— Resistance of the resistor
1 Ohm(default) | positive scalar