Main Content

Detect underflow

Diagnostic action to take when fixed-point constant underflow occurs

Model Configuration Pane: Diagnostics / Type Conversion

Description

The Detect underflow parameter specifies the diagnostic action to take when a fixed-point constant underflow occurs during simulation.

Dependencies

This parameter requires a Fixed-Point Designer™ license.

Settings

none (default) | warning | error
none

Simulink® software takes no action.

warning

Simulink software displays a warning.

error

Simulink software terminates the simulation and displays an error message.

Tips

  • This diagnostic applies only to fixed-point constants (net slope and net bias).

  • Fixed-point constant underflow occurs when Simulink software encounters a fixed-point constant whose data type does not have enough precision to represent the ideal value of the constant because the ideal value is too small.

  • When fixed-point constant underflow occurs, casting the ideal value to the data type causes the value of the fixed-point constant to become zero, and therefore to differ from its ideal value.

Recommended Settings

ApplicationSetting
DebuggingNo impact
TraceabilityNo impact
EfficiencyNo impact
Safety precautionNo impact

Programmatic Use

Parameter:FixptConstUnderflowMsg
Value: 'none' | 'warning' | 'error'
Default: 'none'

Version History

Introduced in R2009b