VL53L0X Time of Flight Sensor

R2026b

Measure distance to a target object

Since R2023a

• 

VL53L0X Time of Flight Sensor for Nucleo block

To add a block to a model, double-click the canvas and start typing the block name. Then, select the block from the list.

Libraries:
STM32 Microcontroller Blockset / (Legacy) STM32 MBED Based Boards / MBED Based Sensors

Description

The VL53L0X Time of Flight Sensor block measures the distance to a target object for a complete field of view (FOV = 25 degrees). This block also provides the option to select one of four ranging modes based on your requirements.

Note

XSHUT connection is required for VL53L0X sensor. Connect the XSHUT pin to vcc.

Ports

Output

Distance — Object distance

vector

The Distance port outputs the target object distance in millimeters

Data Types: uint16

Parameters

I2C module — Module for communication

0 (default)

Specify the module on the board that you are using for I2C communication.

I2C address — I2C address of sensor

0x29 (default)

The I2C address of the VL53L0X sensor from which the block reads the values. You can configure this value. The range of I2C address is from 0x08 to 0x77.

Ranging Mode — Distance ranging mode of VL53L0X sensor

Default (default) | High accuracy | Long range | High speed

Select the distance ranging mode for measuring the distance to the target object. The four ranging modes available are shown in this table.

Ranging mode	Timing budget	Typical max range	Typical application
Default	30 ms	1.2 m	standard
High accuracy	200 ms	2 m	precise measurement
Long range	33 ms	1.2 m	long ranging for dark conditions
High speed	20 ms	1.2 m	high speed where accuracy is not priority

The timing budget is the time taken by the sensor to perform one range measurement.

Sample time — Time interval to read data

-1 (default) | positive integer

Specify how often this block reads the data from the VL53L0X sensor. When you set this parameter to -1, Simulink^® determines the best sample time for the block based on the block context within the model.

Programmatic Use: Add Block

To add the block programmatically, use the add_block function with one of these library block paths as the source.

"stmnucleosensorslib/VL53L0X Time Of Flight Sensor"

Example: add_block("stmnucleosensorslib/VL53L0X Time Of Flight Sensor","myModel/myBlock",MakeNameUnique="on")

Extended Capabilities

C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.

Version History

Introduced in R2023a