Get radio hardware information
hwinfo = info(dev)
dev = sdrdev('E310'); hwinfo = info(dev)
## Establishing connection to hardware. This process can take several seconds. hwinfo = struct with fields: Status: 'Full information' ProtocolVersion: '8.0.0' FirmwareVersion: '8.0.0 for Zynq, build May 16 2017 10:41:59' HardwareVersion: '8.0.0 for Zynq, build May 16 2017 10:18:18' HardwareRxCapabilities: 'Device does not have targeted Rx DUT' HardwareTxCapabilities: 'Device does not have targeted Tx DUT' RFBoardVersion: 'RF Board: No EEPROM information available, PCORE: version 9.0.98' RFBoardRxCapabilities: 'BasebandSampleRate: [520.9kHz,30.72MHz]; CenterFrequency: [70MHz,6GHz]; NumChannels=2' RFBoardTxCapabilities: 'BasebandSampleRate: [520.9kHz,30.72MHz]; CenterFrequency: [70MHz,6GHz]; NumChannels=2'
Before calling the
info function, make sure the SD
card configured during hardware setup is inserted into the reader of the
radio hardware. You can also configure an SD card by using the