Main Content


Build the model that loads and runs an executable on the target hardware

How to deploy Simulink® models and interact with Xilinx® Zynq® Platforms connected to your development computer.


Setup Xilinx Zynq Platform and Software

Install Xilinx software and set up the hardware.

Build and Run Executable on Xilinx Zynq Platform

Build and run executable on Xilinx Zynq platform.

Stop or Restart Executable Running on Xilinx Zynq Platform

Stop or restart an executable running on Xilinx Zynq platform.

Host-Target Communication with External Mode Simulation

Tune parameters and monitor signals through communication channel between development computer and target hardware.

External Mode Simulation by Using XCP Communication

Run external mode simulations that use an XCP communication channel.

External Mode Simulation with TCP/IP

Run external mode simulations that use a TCP/IP or serial communication channel.


Get IP Address of Xilinx Zynq Platform

You can get the IP address of the Xilinx Zynq platform from the MATLAB® Command Window or using the Linux® command line.

Command Line Session with Xilinx Zynq Platform

Open a serial command-line session with Xilinx Zynq platform.

Featured Examples