Standalone Target Computer Setup

Real-time application configuration to be independent of MATLAB®

You can create a real-time application that runs standalone on a target computer, without a development computer running MATLAB. Configure the standalone application so that it starts running when the target computer starts. The application continues for as long as the target computer is operating.

To start and stop the standalone application, tune parameters, and view signal values, use Simulink® Real-Time™ Explorer, either from MATLAB or exported as a standalone executable.


Simulink Real-Time ExplorerInteract with target computer and real-time application running on target computer
Simulink Real-Time Target Computer ManagerInteract with target computer


slrtexplrConfigure target computer and real-time application for execution
SimulinkRealTime.utils.TargetComputerManagerConfigure connection to target computer and real-time application for execution


Standalone Mode

Running your real-time application on the target computer without a development computer.

Standalone Boot Method

Run real-time applications without a development computer.