TI Radar Toolbox with DCA1000EVM Connection - Continuous error occurs when attempting to connect with an Ethernet cable

I failed to connect to the DCA1000EVM in the TI Radar Toolbox.

This is our hardware setting

we are using awr1642boost with dca1000evm capture board

I have provided a screenshot of the device manager and Ethernet IP adress. All networks except for Ethernet have been disconnected.

This is the result of the 'ipconfig' command in CMD

This is the inbound and outbound rule configuration.

How can we solve this error??

Answer 1

[Walter Roberson]

Your ipconfig shows that you have configured the local IP address of the second interface as 192.168.33.30 . However, 192.168.33.30 needs to be the address of the connected device, not the local address of the second interface. You need to configre the second interface address as something else in the 192.168.33.x range (excluding 192.168.33.255). It is probably best to configure the second interface to be 192.168.33.1

[정빈]

Even after following your instructions, i am still getting an error.

What I'm wondering is, I was told to set the IP address to 192.168.33.30 in the hardware setup,

but is it okay to follow your instructions and use that adress??

[Gayatri Menon]

Hi,

Can you please try changing the machine language to English and try Test connection again?

Thanks

Regards

Gayatri

[정빈]

I wanted to take a moment to sincerely thank you for your help and support. Your guidance has been invaluable, and I truly appreciate the time and effort you've invested in assisting me. I am very grateful for your generosity and expertise.

Thank you again for everything. It means a lot to me!

[정빈]

TI RADAR Toolbox with DCA1000EVM disconnetion - MATLAB Answers - MATLAB Central

help....me