Slow Stepper motor rotation
3 views (last 30 days)
Show older comments
Hi,
I am using and Arduino uno plus the adafruit motor shield to control a stepper motor. I installed the ML HW support package for both. The motor is connected as specified and supplied with 6V. It moves similar to whats shown in the examples online. Although I cant increase the rotation speed by very much. RPM stays in the single digits altough the motor should be able to do much more. When I increase voltage the motor starts to run very rough. If I tell it to run at 200 rpm one can see that rotation is not continuous anymore and the motor looses steps.
I suspect some timing issues but cant find an error.
I am sticking the the sample code that comes with the package
0 Comments
Answers (0)
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Arduino Hardware in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!