MATLAB Answers

Design Verifier compatibility with SimEvents blocks

2 views (last 30 days)
Nathan Puryear
Nathan Puryear on 27 May 2021
Commented: Pat Canny on 17 Jun 2021
Is it possible to use property proving in the Design Verifier toolbox with a model using SimEvents blocks? I have tried to add a simple verification property within a verification subsystem to an example SimEvents model, but when I try to run the property prover I get the following error: "Building model representation failed: Simulink Messages blocks support only Normal mode simulation."
I did not alter the example model at all, except for adding a verification subsystem:
Inside the verification subsystem, I added a simple property to prove that the number of rejected parts is less than 10:

Answers (1)

Abdolkarim Mohammadi
Abdolkarim Mohammadi on 29 May 2021
Edited: Abdolkarim Mohammadi on 29 May 2021
I haven't used Design verifier with SimEvents blocks, but I think the error message is clear. The model containing SimEvents blocks and Design verifier blocks must be run only in Normal mode, not Accelerated or other modes.
  6 Comments
Pat Canny
Pat Canny on 17 Jun 2021
Hi Nathan,
In general, yes: Simulink Design Verifier is not compatible with SimEvents blocks. Apologies again for the confusing error message.
Thanks.

Sign in to comment.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!