Model AUTOSAR ECU Power-Up and Power-Down Behavior in Simulink - MATLAB & Simulink
Current Time 0:00
Duration 7:20
Loaded: 2.25%
Stream Type LIVE
Remaining Time 7:20
 
1x
  • Chapters
  • descriptions off, selected
  • captions off, selected
  • en (Main), selected

    Model AUTOSAR ECU Power-Up and Power-Down Behavior in Simulink

    Model the behavior of saving an odometer value to non-volatile memory when ECU goes to sleep using newly introduced Initiate, Terminate, and Preconfigured NvM BSW blocks. Then, perform software-in-the-loop (SIL) simulation for the AUTOSAR model to ensure the algorithm is conforming to requirements.

    Recorded: 10 Mar 2017

    Related Products

    Feedback

    Up Next:

    In this webinar we demonstrate how to develop aircraft electrical networks using Model-Based Design.  Abstract and detailed models of the components in the network are used to enable both rapid iteration and detailed analysis. This webinar includes d

    Aircraft Power Network Development with Model-Based Design

    Related Videos:

    Implement the three most common Maximum Power Point Tracking (MPPT) algorithms using MATLAB and Simulink : Perturb and Observe (P&O), Incremental Conductance, and Fractional Open Circuit Voltage algorithms.

    Implement Maximum Power Point Tracking Algorithms Using...

    Create a plant model that simulates the mechanics and electronics of a robotic assembly.

    Accuracy, Speed, and Power Consumption | Mechatronics with...

    Create flexible designs using Variant Source and Sink blocks for the AUTOSAR target through Simulink and Embedded Coder .

    Model AUTOSAR Variants in Simulink

    Use Maximum Power Point Tracking (MPPT) algorithms in Simulink to maximize the power generated by photovoltaic systems.

    Maximum Power Point Tracking Algorithm Overview

    View more related videos