Main Content

Modeling with Native Floating Point

HDL Coder™ native floating-point technology can generate HDL code from your floating-point design. These are some of the key features:

  • Generation of target-independent HDL code that you can deploy on any FPGA or ASIC.

  • Support for the full range of IEEE-754 features including denormal numbers, exceptions, and rounding modes.

  • Extensive support for math and trigonometric blocks.

You can follow these guidelines as best practices when modeling your design for native floating-point code generation.

Each guideline has a severity level that indicates the level of compliance requirements. To learn more, see HDL Modeling Guidelines Severity Levels.

Guideline ID

1.5.1

Severity

Recommended

Description

Native floating-point support in HDL Coder generates code from your floating-point design. If your design has complex math and trigonometric operations or has data with a large dynamic range, use native floating-point. The generated HDL code is target-independent and complies with the IEEE-754 standard of floating-point arithmetic. To learn more, see Getting Started with HDL Coder Native Floating-Point Support.

You can use these modeling guidelines when using the native floating-point support in HDL Coder.

Use Blocks from HDL Floating Point Operations Library

The HDL Floating Point Operations block library consists of math and trigonometric functions and certain Simulink blocks that are configured for HDL code generation in native floating-point mode. For example, Discrete FIR Filter with Architecture set to Fully Parallel.

Use Floating-Point Types Based on Accuracy and Hardware Resource Usage Requirements

You can generate HDL code for models that contain floating-point and fixed-point data types in native floating-point mode. Floating point types have higher dynamic range but can potentially occupy more area on the target hardware. To design for these trade-offs, in your Simulink® model, it is recommended to use floating-point data types to model the algorithm data path and fixed-point types to model the control logic. To switch between floating-point and fixed-point data types, use Data Type Conversion blocks.

See also Data Type Considerations.

Enable Optimizations such as Resource Sharing on Model

By enabling optimizations on the model, you can improve area and timing of your design on the target FPGA device. For example, to save area on the target FPGA device, use the resource sharing optimization. To share:

See also Resource Sharing.

Simulate Latency of Blocks in Model

Floating-point designs have an inherent latency by default. This latency is added when generating HDL code for your model. It is recommended that you simulate latency in your model by adding this latency information to your original Simulink model. The code generator absorbs this latency during HDL code generation. To learn more, see Latency Values of Floating Point Operators.

Customize Latency of Model or Blocks

You can customize the latency of an entire model, or selectively for certain blocks in your design. Using custom settings, you can specify a custom latency and design for trade-offs between latency and throughput.

To learn more, see Latency Considerations with Native Floating Point.

Use sincos Block Instead of Separate sin and cos Blocks

Certain modeling patterns that you use can optimize your model when you generate code with native floating-point technology. For example, if you are computing the trigonometric sine and cosine of the same input, in the HDL Floating Point Operations block library, use the Sincos block instead of separate Sin and Cos blocks. The Sincos block shares some of the logic that is used for computing the sine and cosine of the input. This implementation reduces the area footprint on the target FPGA device.

See also Trigonometric Function.

Use Tree as the HDL Architecture

To obtain a lower latency implementation, use Tree as the HDL Architecture for blocks such as the Sum of Elements and Product of Elements.

See also Sum of Elements and Product of Elements.

See Also

Functions

Simulink Configuration Parameters

Related Topics