Get number of runs in Simulation Data Inspector repository
the number of runs in the Simulation Data Inspector repository. You can use the run
count to loop over all runs in the Simulation Data Inspector repository to modify
run or signal properties. For example, you could add an absolute tolerance to a
signal in every run.
count = Simulink.sdi.getRunCount
Apply Tolerance to Signal in Multiple Runs
You can use the Simulation Data Inspector programmatic interface to modify a parameter for the same signal in multiple runs. This example adds an absolute tolerance of
0.1 to a signal in all four runs of data.
First, clear the workspace and load the Simulation Data Inspector session with the data. The session includes logged data from four simulations of a Simulink® model of a longitudinal controller for an aircraft.
Simulink.sdi.getRunCount function to get the number of runs in the Simulation Data Inspector. You can use this number as the index for a for loop that operates on each run.
count = Simulink.sdi.getRunCount;
Then, use a for loop to assign the absolute tolerance of
0.1 to the first signal in each run.
for a = 1:count runID = Simulink.sdi.getRunIDByIndex(a); aircraftRun = Simulink.sdi.getRun(runID); sig = getSignalByIndex(aircraftRun,1); sig.AbsTol = 0.1; end
count — Number of runs
Number of runs in the Simulation Data Inspector repository.
Introduced in R2011b