Hardware and Software Requirements

Required MathWorks Products

To use the I/O mode features of the Communications Toolbox™ Support Package for USRP®[1] Embedded Series Radio, the following MathWorks® products are required:

  • MATLAB®

  • Communications Toolbox

  • Signal Processing Toolbox™

  • DSP System Toolbox™

To work with the hardware-software co-design workflow, the following MathWorks products are also required:

  • Simulink®

  • To target the FPGA fabric on the device: HDL Coder™ Support Package for Xilinx® Zynq® Platform (requires HDL Coder)

  • To target the ARM® processor on the device: Embedded Coder® Support Package for Xilinx Zynq Platform (requires Embedded Coder, Simulink Coder™, and the ARM Cortex®-A support package)

Required Third-Party Tools

  • Third-party tools required by the I/O mode features are automatically downloaded and installed during the support package installation.

  • To work with the hardware-software co-design and FPGA targeting workflows, you must manually install the following third-party tools:

    • Xilinx Vivado® development tools, version 2018.2

Hardware Support

Development BoardI/O Peripheral SupportHardware-Software Co-Design Support

USRP® E310

USRP® E312

YesYes

Related Topics


[1] USRP, USRP2, UHD, and Ettus Research are trademarks of National Instruments Corp.