The embedded target for Xilinx Zynq Platform enables you to:
Build a Simulink model that loads and runs an executable on the ARM® Cortex®-A processor embedded in the Xilinx Zynq Platform.
Use the capabilities and features described in Supported Features for Xilinx Zynq Platform
To get this embedded target, perform the steps described in Install Support for Xilinx Zynq Platform.
|Display most recent IP address, user name, and password|
|Run on Hardware Board||Build, deploy, and run models on connected hardware boards|
List of supported Features for Xilinx Zynq Platform
Instructions to install support for Xilinx Zynq platform.
Setup and configure Trivial File Transfer Protocol (TFTP) or Winsock File Transfer Protocol Daemon (WFTPD) to use with your hardware board
Description of how the Embedded Coder® Support Package for Xilinx Zynq Platform verifies the setup of the Xilinx Zynq hardware board.
To check if the Xilinx Zynq platform is properly configured, repeat the steps in TFTP/WFTPD Configuration Guide.
Configure a Network Interface Card (NIC) on development computer to connect to hardware board.
You can get the IP address of the Xilinx Zynq platform from the MATLAB® Command Window or using the Linux® command line.
Open a serial command-line session with Xilinx Zynq platform.
Process to PING an Xilinx Zynq platform connected to your development computer