Multitask conditionally executed subsystem

Select the diagnostic action to take if Simulink^® software detects a subsystem that may cause data corruption or non-deterministic behavior.

Category: Diagnostics

Default: error

none: Simulink software takes no action.
warning: Simulink software displays a warning.
error: Simulink software terminates the simulation and displays an error message.

These types of subsystems can be caused by either of the following conditions:
- Your model uses multitasking solver mode and it contains an enabled subsystem that operates at multiple rates.
- Your model contains a conditionally executed subsystem that can reset its states and that contains an asynchronous subsystem.
These types of subsystems can cause corrupted data or nondeterministic behavior in a real-time system that uses code generated from the model.
For models that use multitasking solver mode and contain an enabled subsystem that operates at multiple rates, consider using single-tasking solver mode or using a single-rate enabled subsystem instead.
For models that contain a conditionally executed subsystem that can reset its states and that contains an asynchronous subsystem, consider moving the asynchronous subsystem outside the conditionally executed subsystem.

Parameter:


                        MultiTaskCondExecSysMsg

Value: 'none' | 'warning' | 'error'

Default: 'error'

Related Topics