Communication Peripherals
Create Simulink® models with the communication peripherals such as CAN, I2C, IPC, SCI, SPI, and more available on TI’s C2000™ microcontrollers. Configure the Simulink model to interface with supported target hardware using model configuration parameters. You can map tasks and peripherals in a model to hardware board configurations using Hardware Mapping tool.
Blocks
Tools
| Hardware Mapping | Map tasks and peripherals in a model to hardware board configurations (Since R2022b) |
Model Settings
Topics
- Configuring LIN Communications
The LIN communications architecture supports a single controller node and up to 16 peripheral nodes on a LIN network.
- Configuring Timing Parameters for CAN Blocks
Lists the specific blocks whose timing parameters are set with the described process
- Communication Between Cores Using IPC Blocks
Use the IPC blocks to communicate between cores in F2837xD and F2838x processors on the TI C2000 processor.
- Enhance Code Execution Speed in TI C2000 Simulink Applications
Optimize code for efficient execution.
- Implement Signal Routing Using C2000 Crossbar (X-BAR)
Overview of crossbar (X-BAR) in C2000™ blockset.
- Exploring TI C2000 Toolchain Options
Utilize TI C2000 toolchains like COFF ABI, EABI, and ARM® to generate code.
- Buffer Logic for Data Transmission
Configure SCI buffers for host-target communication.
Troubleshooting
External Interrupt Workflow for Texas Instruments C2000 Processors
This topic helps you with the workflow for external interrupts.
Troubleshooting External Mode Issues
Troubleshoot the problems when you try to execute TI C2000 Simulink model in External Mode.
Optimizing Baud Rate Settings for External Mode Communication
Optimize baud rates of SCI-A, on-board FTDI, and windows COM port for external mode communication.
Featured Examples
Inter-Processor Communication Using IPC Blocks
Use the IPC blocks to communicate between multiple cores of multi-core of Texas Instruments™ C2000™ Microcontroller Blockset using Simulink® models.
Communication Using CAN Blocks
Use the CAN blocks to set up CAN communication between the target hardware and your host computer for Texas Instruments™ C2000™ Microcontroller Blockset.
Communication with MCAN Blocks
Use the MCAN blocks to set up MCAN communication between the target hardware and your host computer for Texas Instruments® C2000™ Microcontroller Blockset.
Serial Communication Using SCI Blocks
Use the SCI blocks to set up serial communication between the target hardware and your host computer for C2000™ Microcontroller Blockset.
LIN-Based Control of PWM Duty Cycle
Use the C28035 LIN Receive, LIN Transmit, and PWM blocks to generate a pulse waveform.
Using the I2C Bus to Access Sensors
Use the I2C blocks to communicate with I2C based devices.
Using SPI to Read and Write Data to SPI EEPROM
Configure and use SPI blocks to read and write data.
Interface LCD Booster Pack with Texas Instruments C2000 Processors
Configure and use the Kentec QVGA Display Booster Pack to display an image using C28x™ peripherals for Texas Instruments™ C2000™ processors.
Read Position of BiSS-C Absolute Encoder
Read a position of an absolute encoder using the bidirectional serial/synchronous-continuous (BiSS-C) open protocol in the unidirectional mode. This example implements the BiSS-C protocol using TI C2000 peripherals such as CLB, SPI, ePWM, X-BAR, and GPIO using the C2000™ Microcontroller Blockset.
Implement Crossbar (X-BARs) Functionality with C2000 Microcontroller Blockset
Use the Input, Output and ePWM X-BARs available on some of the TI® processors using C2000™ Microcontroller Blockset.
