Get Started with Wireless Testbench

Wireless Testbench™ provides reference applications that are ready to run on off-the-shelf software-defined radio (SDR) hardware such as USRP™ using over-the-air signals for high-speed data transmit, capture, and spectrum monitoring.

Using MATLAB^® command line instructions, you can connect to supported SDR hardware, configure and execute prebuilt FPGA bitstreams as reference applications, and perform real-time measurements.

Using the configurable preamble detector, you can define a trigger to capture only the signal of interest for offline analysis in MATLAB.

Tutorials

• Capture from Frequency Band
  

  Capture IQ data using single radio antenna and plot the frequency spectrum of the captured data.

• Triggered Capture Using Preamble Detection
  

  Capture data from the air upon detecting a preamble sequence.

• Transmit Waveform
  

  Transmit generated waveform using single radio antenna.

• Loopback Transmit and Capture
  

  Transmit and capture generated waveform using single radio.

About Wireless Testbench Reference Applications

• Wireless Testbench Reference Applications on SDR
  

  Learn how Wireless Testbench integrates software-defined radio (SDR) capabilities.

• Supported Radio Devices
  

  List of SDR devices that you can use with Wireless Testbench.