Accumulator for Event-based model...
2 views (last 30 days)
Show older comments
In Simevents I am generating entities and adding an attribute with a varying numeric value. At a later point in my model I would like to accumulate the values of this attribute.
I have attempted to use a discrete-time (and continuous) integrator/accumulator. This does not accomplish the goal because the output of GetAttribute does not go to zero if entities are blocked and so the accumulator continues to add the last value until a new value appears after the system is unblocked.
I also attempted to use a simple Add block with a feedback loop. This doesn't work due to the cyclic nature of feedback. I attempted to add unit delays and/or signal latches per the examples given in the documentation, but the model will not compile saying that there is a loop. Even the example given in the documentation (ex_signal_cycle_latch) fails with the same error.
Am I missing some basic configuration issue? Does anyone have any suggestions on how to accomplish this?
0 Comments
Accepted Answer
Devdatt Lad
on 19 Feb 2013
I assume the feedback accumulator you describe is an Add block whose output is fed back via a Memory block to itself. Try placing this accumulator inside an Atomic Subsystem and set the Memory sample time to be -1 (inherited). When this Atomic Subsystem is connected to the Get Attribute block it will run only when a new entity arrives at the Get Attribute. The documentation example (ex_signal_cycle_delay) shows how such a configuration can be used.
simeventsdocex('ex_signal_cycle_delay')
More Answers (0)
See Also
Categories
Find more on Discrete-Event Simulation in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!