Deployment

Build the model that loads and runs an executable on the target hardware

How to deploy Simulink^® models and interact with Xilinx^® Zynq^® Platforms connected to your development computer.

Model Settings

Hardware Implementation Pane: Xilinx Zynq ZC702/ZC706 Evaluation Kits

Hardware Implementation Pane: Xilinx Zynq ZedBoard

Topics

Set Up Xilinx Zynq Platform and Software
Install Xilinx software and set up the hardware.
Build and Run Executable on Xilinx Zynq Platform
Build and run executable on Xilinx Zynq platform.
Stop or Restart Executable Running on Xilinx Zynq Platform
Stop or restart an executable running on Xilinx Zynq platform.
Host-Target Communication with External Mode Simulation
Tune parameters and monitor signals through the communication channel between development computer and target hardware.
External Mode Simulation by Using XCP Communication
Run external mode simulations that use an XCP communication channel.
External Mode Simulation with TCP/IP
Run external mode simulations that use a TCP/IP or serial communication channel.

Troubleshooting

Get IP Address of Xilinx Zynq Platform

You can get the IP address of the Xilinx Zynq platform from the MATLAB^® Command Window or using the Linux^® command line.

Command Line Session with Xilinx Zynq Platform

Open a serial command-line session with Xilinx Zynq platform.

Featured Examples

Parameter Tuning with External Mode Simulation

Run a Simulink® model in external mode on an ARM® Cortex®-A processor in a Xilinx® Zynq® platform.

Open Live Script

Communicate with the Programmable Logic IP Core on Xilinx Zynq Platform Using AXI4-Lite Protocol

Communicate with the programmable logic IP core on Xilinx® Zynq® platform by using the Advanced eXtensible Interface 4 Lite (AXI4®-Lite) protocol.

Open Live Script

Field-Oriented Control of a Permanent Magnet Synchronous Machine on a Xilinx Zynq Platform

Models a field-oriented controller (FOC) for a permanent magnet synchronous machine (PMSM) on the Xilinx® Zynq®- UltraScale+™ MPSoC target. This example uses the Trenz Electronic™ Motor Control Development Kit TE0820 revision 4. If you do not have the required hardware, you can use this example to help you develop a controller for your own hardware configuration.

Open Live Script