Configure Virtual Vehicle Scenario and Test

Step 3 of 7 in Get Started with the Virtual Vehicle Composer

• 2
• 3
• 4

Use the Scenario and Test pane to configure your virtual vehicle test plan. The available options depend on the virtual vehicle Powertrain architecture and Model template parameter settings.

If you set Scenario to Drive Cycle, you can select:

• Standard drive cycles from industry agencies and institutions. The default selection is the FTP75 drive cycle. Certain drive cycles include gear shift schedules, for example, JC08 and CUEDC.

• Wide open throttle (WOT) parameters, including nominal reference speed and simulation time.

To choose one or more existing drive cycles, click the Scenario and Test tab and follow these steps:

1. From Scenario, select Drive Cycle.

2. From Drive cycle, select a drive cycle.

3. Click Add to Test Plan.

If you select Combined longitudinal and lateral dynamics (not applicable in this example), you can also choose from several vehicle dynamics tests under Scenario.

For this example, use the default FTP75 drive cycle.

Each scenario in the test plan has a default Driver model assigned. The available options depend on the Vehicle dynamics parameter setting.

For this example, set Driver to Longitudinal Driver.