Problem with Enable subsystem in simulink
4 views (last 30 days)
Show older comments
I am simulating a Switched reluctance machine having 4 phases. Each phase is an enabled subsystem enabled by control signals generated from angle feedback. The problem is that even though the control signal is a pulse waveform varying from 0 to 1, the enable signal inside the subsystem is always shown to be 1 (observed from 'show output port'). This means the subsystem is always being enabled.
I am unable to resolve this issue. Please help asap.
0 Comments
Answers (1)
Chandrasekhar
on 21 Mar 2014
Edited: Chandrasekhar
on 21 Mar 2014
The output of the enable subsystem holds the value even if the subsystem is disabled. If you want to reset the output value do as shown in figure below
See Also
Categories
Find more on Subsystems in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!