How to get amplitude of the Signal in 1-phase PLL (Simulink PowerSystems blockset by Pierre Giroux)
7 views (last 30 days)
Show older comments
Hello,
I'm currently using PLL available from matlab simpowersystems to simulate 1-phase inverter for PV connected to grid system. There are 3 Outputs from this PLL model: frequency, wt, and sin_cos in vector form.
My problem is: I need the signal amplitude? I'm actually trying to figure out where's the Vout of the Phase-locked loop?
Can someone tell me how to get the amplitude ?'
thank U very much!
akki
0 Comments
Answers (1)
Dallas Perkins
on 13 Oct 2023
Hi Akki,
I would take a look into the "Sensors and Measurements" library to see if one of those blocks will get you the amplitude that you need. You could use something like the RMS block directly, or feed the output of your PLL into something like a Fundamental (PLL-Driven) block.
0 Comments
See Also
Categories
Find more on Circuit Envelope Simulation in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!