How to switch simulink blocks using a parameter?
2 views (last 30 days)
Show older comments
Hello,
in my Simulinkmodel I want to test different controller blocks. In my "Input Generation"-block I implemented 4 different controllers. Everytime I want to test another controller, I have to remove the input and output connections and make new connections for the new block by hand which is quite annyoing. Is there a way to to this with a parameter? Say if some constant c is equal to 1, I want Controller 1 to be connected to the input and output ports of "input generation" and so on. Thanks for your help.
0 Comments
Accepted Answer
Jordan Ross
on 24 Jan 2017
Hello Martin,
What you are going to want to use is actually is a "variant subsystem". The following documentation page discusses what they are:
However, of more interest to you is the following documentation page which contains an example of modeling different variants of controllers:
More Answers (0)
See Also
Categories
Find more on Subsystems in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!