Help ---> matrices X and Y must have the same size as Z
1 view (last 30 days)
Show older comments
x = 0.01:0.01:2;
y = 0.01:0.01:2;
z = 0.01:0.01:2;
rex = reshape(x,10,20)
rey = reshape(y,10,20)
rez = reshape(z,10,20)
% Variable 'x' denotes the draw current of the device. It is also
% the current that is running through the wire. Measured in Amps (A).
% Value --> 0.01 Amp to 2 Amp with an interval of 0.01 Amp
% Variable 'y' is the time in seconds (s). This variable is used to
% characterize the AC current graph that is a sine wave.
% Value --> 0.01 s to 2 s with an interval of 0.01 s
% Variabe 'z' is the distance from the current carrying conductor
% measured in centimeters (cm).
% Value --> 0.01 m to 2 cm with an interval of 0.01 m
[X,Y,Z] = meshgrid(rex,rey,rez);
% Meshgrid creates a 3-dimensional coordinate taking in values
% x, y, z
B = ((4*pi^-7)*(X.*sin(Y.*60)))./((4*pi)*(Z.^2));
% B is a multivariable function that takes in the values of x,y,z.
% It is the calculated magnetic flux density produced by a current
% carrying conductor.
for level = 0.2:0.2:0.8
isosurface(X,Y,Z,B, level);
% isosurface is MATLAB function used to plot the dependent variable
% with all the independent variable (X,Y,Z) into a surface plot
% The function or keyword level the a MATLAB feauture to denote
% the gradient level used in the color bar
title('Magnetic flux density')
xlabel('Amp (A)')
ylabel('Time (s)')
zlabel('Distance (m)')
cb = colorbar;
% properties of the graph
end
quiver3(X,Y,Z,B) % <--I AM GETTING THE WARNING HERE
1 Comment
Answers (0)
See Also
Categories
Find more on Surface and Mesh Plots in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!