How to use PS Lookup Table
3 views (last 30 days)
Show older comments
Adrian Klimczak
on 28 Feb 2020
Answered: Prasanna Gude
on 3 Mar 2020
Is it possible to use Lookup table within the electrical Simscape, meaning voltage is inputted to the lookup table and that table outputs other voltage based on the input?
We are aware of PS Lookup Table, but we have not managed to successfully use it. The only way to use it, appears to be to use Voltage Sensor to plug V into x of PS Lookup Table. Then connect f of PS Lookup table to Controlled Voltage Source. But I am not sure if this is correct way.
There is also Simulink Lookup Table, but we were not able to plug it into electrical circuit.
Any advice if this is possible at all, and if it is what is the correct way to do it?
0 Comments
Accepted Answer
Prasanna Gude
on 3 Mar 2020
Yes, it is possible to use PS Lookup Table in an electrical circuit. Refer to the following link to know more about PS Lookup Table:
If you do want to connect Simulink Lookup Table to an electrical circuit, first connect the PS-Simulink Converter block to the electrical circuit and then connect Simulink Lookup Table block to it.
0 Comments
More Answers (0)
See Also
Categories
Find more on Composite Components in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!