Cannot boot RTTarget-32 from Virtual 8086 mode
5 views (last 30 days)
Show older comments
Hi, when took an example about xPC Target Stand Alone in matlab help 2012b, i took the steps in the help, and the only different was tha i had not edit the autoexec.bat located in the C:\ with dos commands, i edit it in xp with txt in xp syttem insteard, and when i finished transfering file from the host computer to the target computer and editing the autoexec.bat. i reboot my target computer in dos system, but the system returned some information as below: "RTTarget-32 DOS Boot Utility 5.23(c) 1996,2011 On Time Informatik GmbH Cannot boot RTTarget-32 from Virtual 8086 mode"
and the target computer had not run the model i transfered to it, could anybody give me some favour about these prombles, or is there anybody who met the same problems.
3 Comments
Answers (0)
See Also
Categories
Find more on Multicore Processor Targets in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!