How to keep same time range when sending data form Simulink to Matlab?
2 views (last 30 days)
Show older comments
hi, I am Simulating a model in simulink and want to plot a graph of the output in MatLAB, but when i send it to MatLAB the time range changes, for example, when its in Simulink, its 300 seconds but when sent to MatLAB its 1200 seconds, basically I want the same response from the scope only in MatLAB.
Thanks
Johnny
0 Comments
Accepted Answer
Fangjun Jiang
on 2 May 2011
I suspect you are viewing partial of your curve in Simulink scope. See this post: http://www.mathworks.com/matlabcentral/answers/5591-scope-time-not-shown-to-full-simlation
You may have ploted your curve in Matlab without time so your x-axle is just number of data samples. By default, the simulation time is sent to the workspace as "tout", so try, plot(tout, YourVariable). You can change this by click menu:
Simulation-> Configuration parameters ... -> Data Import/Export
4 Comments
papan dey
on 6 Feb 2013
i have generated simulink figure and can convert it in matlab using plot(signal) . now if i want to take the graph between a time limit such as 0.2s t0 0.5s, which command should i write?
More Answers (0)
See Also
Categories
Find more on Sources in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!