Why does the Signal Editor not interpolate my signals

Hello,

I have a Model with a Signal Editor for external inputs. The signal I want to input is actually a Bus with several signals of single type and one enumeration.

Because of the enumeration in the bus I can not check the option "Interploate data" in the Block Parameters Dialog of the Signal Editor, otherwise I get an error when trying to simulate.

The interpolation method for each signal (except for the enumerated one) is set to linear.

But when I run the simulation the interpolation of all the signals is treated as zoh.

Any idea how to solve this keeping the enumeration inside the Bus?

[Tousif Dange]

I have the same issue in Matlab 2022b. Signal builder does not interpolate the signal even after setting as mentioned above

[Gábor]

I have the same issue in 23b, interpolation is set to linear, still the output is not interpolated. Anyone managed to solve this?

[Yukthi S]

Have you looked into this answer?

https://in.mathworks.com/matlabcentral/answers/762901-interpolation-in-the-signal-editor-block-is-not-working?s_tid=answers_rc1-1_p1_Topic