My ICA topography maps all look the same, blue and yellow with activity reflected in the same region for all topo plots

I am trying to plot the result of ft_componentanalysis with ft_topoplotIC.

figure
cfg = [];
cfg.component= 1:64;
cfg.layout= 'NEAAD".mat'  
%my layout file is derived from easycapM1.mat since it has the closest layout to the electrode cap layout I used in my experiemeent. 
% However, I manually adjusted the electrode positions to my cap in the lay.pos to match the electrode positions I use
cfg.comment='no';
ft_topoplotIC(cfg, comp)

I get these warnings

Duplicate x-y data points detected: using average values for duplicate points. 
Warning: could not determine dimord of "comp" in:
             label: {64×1 cell}
               cfg: [1×1 struct]
              topo: [64×1 double]
        topodimord: 'chan_comp'
              comp: 64
          unmixing: [1×64 double]
    unmixingdimord: 'chan_topochan'
    

As mentioned, I do get topgraphy maps but they all look like the same 2 variations as portray in the picture below.

I have attached also my layout file I have used. I am not using eeglab for this as I was instructed not to.