- Use a 'switch' block to pass 'eps' instead of 'u' to the 'divide' denominator. The 'switch' must only be activated when the signal 'u' is zero.
- Use a 'MATLAB Function' block to implement a zero-avoiding condition, such as:
How can I avoid errors due to division by zero in Simulink?
387 views (last 30 days)
Show older comments
MathWorks Support Team
on 13 Mar 2012
Edited: MathWorks Support Team
on 15 Jul 2024
I am using a simple model in Simulink in which I use a division on two input values using a 'Divide' block.
During my simulation, there might be a zero value fed to the denominator of the 'Divide' block. This often causes a warning, an error message, or erroneous results.
How can I avoid these problems?
Accepted Answer
MathWorks Support Team
on 15 Jul 2024
Edited: MathWorks Support Team
on 15 Jul 2024
Numerical division by zero is a common issue in programming, and its exact solution often depends on the particular application. In almost all cases, the best approach is to change the model to never feed zero to a division block.
An example of a workaround is shown below. For clarity purposes, let us call the original signal in the denominator as 'u'.
u + (u==0)*eps
or, if the signal 'u' is real:
u + eps*(0^u)
1 Comment
More Answers (1)
madhan ravi
on 10 Jan 2024
Or making the result to be zero when the divisor is zero using a Switch block
0 Comments
See Also
Categories
Find more on General Applications in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!