Search results: answered_by_id:253940 - MATLAB Answers

6 questions found in Answers

Results 1 - 6 of 6

3

answers

0 votes
1 view

Chang center frequency quickly

Asked by Ardeal Liang on 24 Oct 2018

Latest activity Commented on by Paul on 6 Nov 2018

Accepted Answer by Ardeal Liang

Code Generation HDL Coder Targeting FPGA & SoC Hardware

1

answer

0 votes
4 views

How to control GPIO of ARM on Zedboard

Asked by Ardeal Liang on 25 Oct 2018

Latest activity Commented on by Ardeal Liang on 6 Nov 2018

Code Generation HDL Coder Targeting FPGA & SoC Hardware

1

answer

0 votes
3 views

Run transmitter and receiver model in 1 model or 2 separate model in parallel

Asked by Ardeal Liang on 18 Oct 2018

Latest activity Commented on by Ardeal Liang on 25 Oct 2018

Accepted Answer by Paul

RF and Mixed Signal RF Blockset RF Blockset Models for Transceivers

1

answer

0 votes
5 views

The received signal from sdrrx keeps unchanged even if I connect or disconnect the loopback cable to trainsmitter port TxA and receiver port RxA

Asked by Ardeal Liang on 23 Oct 2018

Latest activity Commented on by Paul on 23 Oct 2018

Accepted Answer by Paul

Cloud Capabilities MATLAB Mobile

3

answers

0 votes
4 views

Question about how to run TX and RX calibration example model on zedboard with zynq

Asked by Ardeal Liang on 18 Oct 2018

Latest activity Commented on by Paul on 23 Oct 2018

Accepted Answer by Paul

Code Generation Embedded Coder Deployment, Integration, and Supported Hardware Embedded Coder Supported Hardware Texas Instruments C2000 Processors

2

answers

0 votes
4 views

Zynq Radio Software Interface Model: UDP send/receive blocks not working

Asked by Hewy.j on 15 Aug 2018

Latest activity Commented on by Hewy.j on 21 Aug 2018

Accepted Answer by Paul

Code Generation HDL Coder Targeting FPGA & SoC Hardware

Results 1 - 6 of 6

Filter By

Status Clear

Source Clear

Category Clear

3

Chang center frequency quickly

1

How to control GPIO of ARM on Zedboard

1

Run transmitter and receiver model in 1 model or 2 separate model in parallel

1

The received signal from sdrrx keeps unchanged even if I connect or disconnect the loopback cable to trainsmitter port TxA and receiver port RxA

3

Question about how to run TX and RX calibration example model on zedboard with zynq

2

Zynq Radio Software Interface Model: UDP send/receive blocks not working