Pooja
Followers: 0 Following: 0
Statistics
RANK
24,357
of 300,365
REPUTATION
1
CONTRIBUTIONS
5 Questions
1 Answer
ANSWER ACCEPTANCE
40.0%
VOTES RECEIVED
1
RANK
of 20,933
REPUTATION
N/A
AVERAGE RATING
0.00
CONTRIBUTIONS
0 Files
DOWNLOADS
0
ALL TIME DOWNLOADS
0
RANK
of 168,262
CONTRIBUTIONS
0 Problems
0 Solutions
SCORE
0
NUMBER OF BADGES
0
CONTRIBUTIONS
0 Posts
CONTRIBUTIONS
0 Public Channels
AVERAGE RATING
CONTRIBUTIONS
0 Highlights
AVERAGE NO. OF LIKES
Feeds
Question
Regarding configuremodelsim, It does not configure the selected modelsim
Hello, For HDL Co-simulation in MATLAB 2011a, I have two modelsim installed on my machine 1)Modelsim XE 6.2c and then I insta...
12 years ago | 3 answers | 1
3
answersQuestion
Error while running FIL Wizard for Atlys Spartan 6 kit.
Hello, I am using MATLAB r2011a, I am able to program FPGA with the FIL Wizard, but when I try to run the model, it shows fol...
12 years ago | 1 answer | 0
1
answerQuestion
Error in S-function while running FPGA-in-the-loop, FIL Wizard
Am using MATLAB r2011a, I have made simulink model and using FIL wizard for Atlys Spartan 6 kit. Am successfully able to gener...
12 years ago | 1 answer | 0
1
answerQuestion
Simulink block for switching: Multiport switch block not supported in HDL Coder
Hello, I am using Matlab 2011a. In simulink when i use Multiport Switch block, the HDL Compatibility test gives following Error...
12 years ago | 1 answer | 0
1
answerI am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
Hi Tim, Thanks for your response. I tried specifying pin numbers as {'1', '2', '3', '4', '5', '6', '7', '8', '9', '10', '11'...
12 years ago | 0
| accepted
Question
I am using MATLAB R2011a, am getting error in HDL workflow advisor Set target interface, FPGA pin specification.
I have selected Atlys Spartan 6 development board. In Set target interface, when i am specifying interface as "Specify FPGA Pin...
12 years ago | 2 answers | 0
