Oliver McEnteggart
Followers: 0 Following: 0
Statistics
RANK
10,630
of 298,313
REPUTATION
4
CONTRIBUTIONS
8 Questions
1 Answer
ANSWER ACCEPTANCE
62.5%
VOTES RECEIVED
4
RANK
of 20,563
REPUTATION
N/A
AVERAGE RATING
0.00
CONTRIBUTIONS
0 Files
DOWNLOADS
0
ALL TIME DOWNLOADS
0
RANK
of 160,817
CONTRIBUTIONS
0 Problems
0 Solutions
SCORE
0
NUMBER OF BADGES
0
CONTRIBUTIONS
0 Posts
CONTRIBUTIONS
0 Public Channels
AVERAGE RATING
CONTRIBUTIONS
0 Highlights
AVERAGE NO. OF LIKES
Feeds
Question
Running sequential simulations in a simulink model
I have a simulink model with a set of about 10 parameters. I also have a set of about 15 different sets of parameters, I am tryi...
12 years ago | 1 answer | 2
1
answerOutput first zero of a signal?
Thanks for that help, I have another related question though how would I go about finding the time difference between each succe...
12 years ago | 0
Question
Output first zero of a signal?
Is there anyway to output the first time at which a signal is zero (excluding at t = 0)?
12 years ago | 3 answers | 0
3
answersQuestion
How to I output the maximum value of a signal to a display?
Is there anyway to output the maximum value of a signal that varies with time in simulink to a display block?
12 years ago | 1 answer | 0
1
answerQuestion
How to route a signal without routing it through every layer in a simulink model
Is there anyway to route or find the value of a signal that is in a reference model several subsystems below the outer level dir...
12 years ago | 1 answer | 0
1
answerQuestion
Extracting a response time in simulink
So I have a control system in simulink which I have put into a test harness and I want to find the response time for that system...
12 years ago | 1 answer | 0
1
answerQuestion
Error: Cannot propogate bus signal from output 1 to input 5
I keep getting this error when I try to run a simulation with a model reference. The signal is created by a subsystem which then...
13 years ago | 1 answer | 1
1
answerQuestion
Nested buses in base workspace
I'm trying to define a nested bus structure in the base workspace of MatLab. However, I'm not sure how I should actually write t...
13 years ago | 1 answer | 1
1
answerQuestion
Test harnesses and reference models
Hi, I am making a test harness in simulink to test an actuator model and have ran into a problem. The actuator itself is a re...
13 years ago | 1 answer | 0
