photo

Amrutha


Active since 2014

Followers: 0   Following: 0

Message

Statistics

  • Thankful Level 1

View badges

Feeds

View by

Question


nco output multiplied with digitised data in SIMULINK
When i multiplied the output of NCO with a digitised signal in SIMULINK, the output frequency spectrum shows only the influence ...

10 years ago | 0 answers | 0

0

answers

Question


maximum frequency output we get from NCO in SIMULINK
What is the maximum frequency output we get from NCO in SIMULINK?When i set the sample time in NCO to (1/10^6),it shows memory a...

10 years ago | 0 answers | 0

0

answers

Question


Simulink operations became slow
Hi, My simulink suddenly became very slow.Earlier simulink operations used to work very quickly.i have not done anything differ...

10 years ago | 3 answers | 0

3

answers

Question


OBSERVING SIGNAL GENERATOR OUTPUT AT HIGH FREQUENCY IN SIMULINK
Hi, In simulink,when i use signal generator at low frequency(egs:1 rad/sec) and observe the sine wave in a scope,my output is ...

10 years ago | 1 answer | 0

1

answer

Question


how to observe the output of digital filter?
Hi, I am new to simulink.Inorder to observe the output of digital filter(lowpass) ,to what sink should i connect my filter.i tri...

10 years ago | 1 answer | 0

1

answer

Question


to what sink should i connect to observe the output of digital filter.
Hi, I am new to simulink.Inorder to observe the output of digital filter(lowpass) ,to what sink should i connect my filter.i tr...

10 years ago | 0 answers | 0

0

answers

Question


About increasing the output duration of a signal generator
Hi, I am new to simulink.when i observe the signal genrator output in a scope ,i see that the signal appears only for 10 units....

10 years ago | 1 answer | 0

1

answer

Question


how to observe digital outputs in simulink?
hi, i am new to simulink.how can i observe the output of lowpass filter in this example.To view analog signals we can use scope...

10 years ago | 1 answer | 0

1

answer