Deployment

Build the model that loads and runs an executable on the target hardware

How to deploy Simulink^® models and interact with AMD^® SoC Devices connected to your development computer.

Model Settings

Hardware Implementation Pane: AMD Zynq ZC702/ZC706 Evaluation Kits

Hardware Implementation Pane: ZedBoard

Topics

Set Up AMD SoC Devices and Software
Install AMD SoC device software and set up the hardware.
Build and Run Executable on AMD SoC Devices
Build and run executable on AMD SoC devices.
Stop or Restart Executable Running on AMD SoC Devices
Stop or restart an executable running on AMD Zynq board.
Host-Target Communication with External Mode Simulation
Tune parameters and monitor signals through the communication channel between development computer and target hardware.
External Mode Simulation by Using XCP Communication
Run external mode simulations that use an XCP communication channel.
External Mode Simulation with TCP/IP
Run external mode simulations that use a TCP/IP or serial communication channel.

Troubleshooting

Get IP Address of AMD SoC Device

You can get the IP address of the AMD SoC device from the MATLAB^® Command Window or using the Linux^® command line.

Command Line Session with AMD SoC Devices

Open a serial command-line session with AMD SoC devices.

Featured Examples

Parameter Tuning with External Mode Simulation

Run a Simulink® model in external mode on an ARM® Cortex®-A processor on an AMD Zynq® board.

Open Live Script

Communicate with the Programmable Logic IP Core on AMD Zynq Board by Using AXI4-Lite Protocol

Communicate with the programmable logic IP core on an AMD Zynq® board by using the Advanced eXtensible Interface 4 Lite (AXI4®-Lite) protocol.

Open Live Script

Basic Control Algorithm Partitioned into FPGA and ARM

Models a field-oriented controller (FOC) for a permanent magnet synchronous machine (PMSM) on the AMD Zynq® UltraScale+™ MPSoC target. This example uses the Trenz Electronic™ Motor Control Development Kit TE0820 revision 4. If you do not have the required hardware, you can use this example to help you develop a controller for your own hardware configuration.

Open Live Script