Forward and feedback controllers in SISOtool.
3 views (last 30 days)
Show older comments
Mathias
on 26 May 2014
Commented: Arkadiy Turevskiy
on 14 Jul 2014
Hello.
I have two different controllers in a feedback loop which I'd like to keep seperated. My problem is that the architectures in SISOtool that support 2 controllers, I can't really "block algebra" my setup to look like those while still keeping the controllers seperated.
What I have is the following:
where C and F would be my controllers.
Any advise is really apprecieated.
Regards Mathias
0 Comments
Accepted Answer
Arkadiy Turevskiy
on 18 Jun 2014
Hi Mathias,
Unfortunately there is no way to do this now with SISO Tool. The only option is to tune C first using configuration 1, and use F using configuration 2.
Of course you could still tune them without SISO Tool too. Arkadiy
8 Comments
Arkadiy Turevskiy
on 14 Jul 2014
you are welcome. you show your appreciation by accepting the answer - that's it.
More Answers (0)
See Also
Categories
Find more on Loop-Shaping Design in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!