AD-FMCOMMS5 using MATLAB SD card image RX tuning failed!

Hello All,

I imaged the SD card from ZYNQ communication tool box setup.

I'm getting this error in the reported data at the UART console after boot up:

[ 436.350902] SAMPL CLK: 3000000 tuning: RX

[ 436.354901] 0:1:2:3:4:5:6:7:8:9:a:b:c:d:e:f:

[ 436.359287] 0:# # # # # # # # # # # # # # # #

[ 436.363829] 1:# # # # # # # # # # # # # # # #

[ 436.368263] ad9361 spi32766.1: ad9361_dig_tune_delay: Tuning RX FAILED!

[ 437.416787] SAMPL CLK: 3000000 tuning: RX

[ 437.420761] 0:1:2:3:4:5:6:7:8:9:a:b:c:d:e:f:

[ 437.425175] 0:# # # # # # # # # # # # # # # #

[ 437.429599] 1:# # # # # # # # # # # # # # # #

[ 437.434037] ad9361 spi32766.1: ad9361_dig_tune_delay: Tuning RX FAILED!

[ 438.484925] mwipcore 43c50000.mwbypassrx: [MMAP] size:10000 pgoff: 0

[ 438.491554] mwipcore 43c50000.mwbypassrx: Simple VMA close.

[ 438.664892] mwipcore 43c50000.mwbypassrx: [MMAP] size:10000 pgoff: 0

[ 438.671518] mwipcore 43c50000.mwbypassrx: Simple VMA close.

[ 441.938035] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 441.947493] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 441.957100] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 441.966586] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 441.976106] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 441.986524] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.102520] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.112013] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.122675] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.133221] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.143705] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.154185] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.280004] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

[ 442.291991] mmcblk0: response CRC error sending r/w cmd command, card status 0x900

Any help is highly appreciated!

Kind Regards

Arash