How do I use the Varying State Space Block in Simulink Simulating returns errors. An example would be helpful

1 view (last 30 days)

Answers (1)

Abhaya
Abhaya on 17 Sep 2024
Hi Bay Jay,
The Varying State Space block in Simulink is particularly useful for systems where the state-space representation changes over time or depends on certain parameters.
Here's a simple example to demonstrate a second-order linear time-invariant system using the Simulink Varying State Space block.
The model uses five Simulink ‘constant blocks as inputs to the Simulink ‘Varying State Space’ block. The Constant block labelled "signal" is configured with a value of 1. The value of the other constant blocks are set as follows:
  • A_mat = [0,1;-2,-1];
  • B_mat = [0;1];
  • C_mat = [1 0];
  • D_mat = [0];
These matrices define state matrix (A), input matrix (B), output matrix (C) , and feed forward matrix (D). Once set up, you can run the simulation to observe the output of the model.
For more information, please follow the MATLAB documentation link for the Simulink ‘Varying State Space’ block.
If you encounter any errors while implementing the Simulink Varying State Space block, here are some troubleshooting tips:
  • Ensure that you are following the dimension restrictions given in the 'Ports' section of the MATLAB documentation for the Varying State Space block.
  • If you are using a Constant block, try unchecking the "Interpret vector parameters as 1-D" option in ‘Block parametersmenu of the constant block, as this can sometimes resolve dimension mismatch issues.
I hope this helps! 

Categories

Find more on Simulink in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!