How to solve the problem that, does the following resistor block value match the plotted requirement resistor: V?

this's last tast in onramp cours Power electronic. after connecting the components like requiet in the course this message of error are coming. The resistor block value match the plotted requirement resistor: V.

[Luuk]

I have the same issue with creating hte buck converter can you tell me if you solved it?

Answer 1

[Pranjal Saxena]

Hi Mukendi,

I understand that you are getting error as you have not added the solver configuration block to your physical network.

Each physical network represented by a connected Simscape block diagram requires solver settings information for simulation. The Solver Configuration block specifies the solver parameters that your model needs before you can begin simulation.

Every physical network needs a Solver Configuration block. If you have several physical networks and some Simulink Blocks in between you will have to use one Solver Configuration for each physical network.

Refer to following documentation for further understanding on Simscape and Solver configuration:

Physical network environment and solver configuration - MATLAB (mathworks.com)

Add line to Simulink model - MATLAB add_line (mathworks.com)

How Simscape Simulation Works - MATLAB & Simulink (mathworks.com)

Setting Up Solvers for Physical Models - MATLAB & Simulink (mathworks.com)

I hope this helps.

Warm Regards,

Pranjal.

[Saanvi]

Added but still getting the same error.

[Sk]

I have the same issue

[Sk]

[Abhinand]

i agree with @Sk even im getting the same error this is in circuit simulation OnRamp

[Abhinand]

@Sk and @Mukendi Alonso if you are still struggling go to the next part cut the content and paste it to previous and change diode breakdown voltage to 3V you are good to go