- Q leads D, rotor angle measured from A-phase to D-axis
- Q leads D, rotor angle measured from A-phase to Q-axis
- D leads Q, rotor angle measured from A-phase to D-axis
- D leads Q, rotor angle measured from A-phase to Q-axis
Flux weakening equation issue
4 views (last 30 days)
Show older comments
i have modelled using subsystem block for flux weakening equation(IPMSM) which is available in mathworks website.but output of id,iq is not match with motor cad id iq.
Notes:8500 rpm 15 Nm
did i model properly?
0 Comments
Answers (1)
Sabin
on 28 Sep 2023
First, the equations are implemented based on constant parameters, basically ignoring some physical phenomena that motor cad may include. Second, I would check if the definition for axis transformation is the same in the equations you are implementing and in motor cad. It is not uncommon for FEM tools to use a different definition that what a control engineer would use. The are 4 possible definitions:
More about the axis definition you can find in the FEM-Parameterized PMSM doc page:
0 Comments
Communities
More Answers in the Power Electronics Control
See Also
Categories
Find more on Electromechanical in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!