Power supply control using Instrumental control tool box

How to control the power supply using the Instrument control tool box in the Simulink.

Answer 1

[praguna manvi]

Hi @Ravi Sankar,

As I understand it, you are looking to control a power supply using the “Instrument Control Toolbox.” This is possible by using the “SCPI” commands found in the operating or programming manual for the power supply. You can control any power supply over these supported interfaces: “GPIB,” “Serial,” “TCP/IP,” “UDP,” “VISA.”

Here is a link to the documentation which provides an overview of supported interfaces and more information on power supply control using the “Instrumentation Control Toolbox”:

https://www.mathworks.com/products/instrument/supported/power-supply.html

For more information on using “SCPI” commands refer to:

https://www.mathworks.com/help/instrument/use-scpi-commands.html

Hope this helps!