How to scope and print UART data from STM32F4 evaluation board?
6 views (last 30 days)
Show older comments
Hello all,
I am currently struggling to find out how to scope and print out an array of hex data as shown below.
It currently shows all zeros although the oscilloscope shows some data going to and coming from the STM32F4 board.
All wiring setup is correct since I successfully tested some other tasks.
I appreciate your help in advance.
1 Comment
madhan ravi
on 6 Jan 2024
Edited: madhan ravi
on 6 Jan 2024
As the message says , the Stm32 board uses a local timer so simulation time is not based
Accepted Answer
Jung Sunghun
on 7 Jan 2024
1 Comment
madhan ravi
on 7 Jan 2024
Perfect, thanks for providing feedback. Will be always useful for others as well. I knew how to do it in STM32Cubeide but not in Simulink since I don’t have the license.
More Answers (0)
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!