An error occurred while running the simulation and the simulation was terminated

I'm trying to model a MicroGrid protection circuit with a Wind Turbine Induction Generator and an ACDCAC converter. Whenever I run the simulation I get the following error:

An error occurred while running the simulation and the simulation was terminated

Caused by:

Block 'windmillacdcac10x2810x29/Wind Turbine Induction Generator (Phasor Type)/Asynchronous Machine/Electrical model/Asynchronous Machine State-space model/Electromagnetic Torque/Mult1' outputs 'Inf' for element 1 of output port 1 at major time step 6.8E-05

Before this the simulation error asked me to change the Discrete Solver parameter of the Asynchronous Machine Block inside the Wind Turbine Indcution generator model from Forward Euler to Trapezoidal. I did that and the above error is the result. I've attached photos of the main circuit as well as the Wind turbine induction generator block and the Multi1 block. Hope somebody can help me fix this.

Answer 1

[Ngo]

To address this issue, you need to review the parameters and settings of the blocks in your model. Specifically, you need to examine why the "Mult1" block is returning an infinite value and consider any adjustments necessary to rectify this problem. Sometimes adjusting the parameters of the block or reviewing the logic of the model can help resolve the issue.