In 5G Toolbox the system-level simulation is very slow
4 views (last 30 days)
Show older comments
I'm using the PHY abstraction in The System-Level Simulation, yet the code runs very slowly (several hours to process a few frames on an ordinary Dell laptop). I have multiple cells (3) and multiple users per cell (6) , so that has an obvious impact on the run-time, but these are small numbers. Are there any tricks to speed this up? Our code is similar to provided examples such as "NR Cell Performance with Downlink MU-MIMO" and "NR Intercell Interference Modeling." I tried setting enableTraces to false, but that didn't help. I see there is a variable 'numMetricsSteps' that the code states affects simulaiton time, but I'm not sure if lowering it it will reduce accuracy?.Any other suggestions for speed-up?
0 Comments
Answers (1)
Shubham
on 24 May 2024
Hey Laurence,
Refer to the following suggestions for improving simulation time:
You may also use profiling tools to your advantage:
Although these are general suggestions but I hope these would help you out.
See Also
Categories
Find more on Introduction to Installation and Licensing in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!