How to change pole configuration for Commutation of SRM Using Sensor Feedback example?
9 views (last 30 days)
Show older comments
The Commutation of SRM using sensor feedback in this example uses a 12/8 SRM motor configuration using TI F28379D. Is it possible to change the poles to configure it for a 6/4 SRM motor instead? If so, how can the configuration be modified in the Simulink example?
0 Comments
Answers (1)
praguna manvi
on 28 Oct 2024
Edited: praguna manvi
on 29 Oct 2024
As I understand, you are referring to the example of “Commutation of SRM Using Sensor Feedback” available at this link:
To change the pole configuration, you can set the “Three-phase SRM” block’s number of rotor poles to 4 in the “Power Converter and Motor” subsystem of the example as shown here
For additional information on the “Switched Reluctance Machine,” refer to this link:
Hope this helps!
0 Comments
See Also
Categories
Find more on Motor Drives in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!