How to change a block parameter using SimState?
Info
This question is closed. Reopen it to edit or answer.
Show older comments
Hello everybody.
I'm trying to simulate different types of faults in a Simulink electrical power system. Then, I'm using SimState to get the system steady-state and from this point I want to apply the faults and check the behavior.
Thus, I'm using the Three-Phase Fault block to apply the fault and I need to change the type of fault at this block after SimState is loaded but system consider that is an error. How can I fix it?
Answers (0)
This question is closed.
on 5 Apr 2017
Closed:
on 23 Dec 2024
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
