transmitting and recieving with pcan usb (peak System)

Hi everyone, I am trying to use VNT peak system toolbox.After a bit of installing/deinstalling drivers etc, I got it to work.Now, here there is an error I can not resolve. I need to transmit and recieve messages to the controller in the same sim.model.

Well, whenever i deactivate the transmit or recieve part it works, but not at the same time, which what i need to have. The error i am getting is:

"Unable to query hardware information for the selected
CAN channel object.Struct contents reference from a non-struct array object."

for the simultaneous send/recieve. I can not figure out where or which setting I should change.I would appreciate any hint, help that you may think of.

Thanks in advance,

cheers

Kaveh

[Kaveh Allahdin]

By the way. After I updated my windows the problem went away! so the lesson is to keep your windows up to date always! :)

Answer 1

[Kaveh Allahdin]

I did not post unpacking for The recieving but that changes nothing!the moment I add receive can to the canvas it starts complaining!

[Kaveh Allahdin]

I checked! I can not even run the matlab examples.However using pCanview i can send/receive with no problem!