I am using a R2011b matlab (32bits) which has a simulink demo "six-phase synchronous machine with pose-fault operating strategy". The six-phase syn motor is running fine with the mechanical power Pm as the mechanical input. However, whenever I switch the input to speed w, an initialization error prompts as:
Error due to multiple causes. --> Error in "Power 6phsyncmachine/Six Phase Synchronou Machine 240V 100KVA": Initialization commands cannot
be evaluated. --> Block choice 'Continuous' is not a valid member of 'Power 6phsyncmachine/Six Phase Synchronous Machine 240 100KVA/Mechanical model'
which is the cause?